Plumbing Tips That Will Save You Money

How much do you really know about your home’s plumbing? If so, wouldn’t it be nice to build upon your knowledge? Just what are your plumbing skills? If you’re unsure of your answers to these questions, you need to read this article.

If any water pipe that you have freezes, be sure to turn on the faucet that is closes to the pipe to give the water an exit as the pipe thaws. By doing this, the pipe pressure is relieved, and this should stop it from bursting, which would prevent further home damage.

Keep your plumbing flowing by maintaining a temperature above 32 degrees and wrapping up any exposed pipe works. Pipes have the potential to freeze if the surrounding temperatures are below the freezing mark. At best, it can take time for them to thaw and for you to be able to have running water. At worst, they will burst and you’ll be paying to repair the damage.

Septic Tank

Ensure that a septic tank is emptied approximately five yearly, and make sure it is properly maintained. Having your septic pumped will keep sediments from settling to the bottom of the septic tank and causing the tank to malfunction or backup. White it is somewhat expensive to pump the septic tank, it will be much more expensive should you need to clean backup, repair your septic tank or replace it altogether.

Do not give a plumber the entire payment for a job until the whole job is completed. There might be a down payment required, but you do not give him the total cost before he is finished. Knowing the job was completed in a timely and high-quality manner is essential before paying for a plumber.

You can pour baking soda down a drain followed by some vinegar if you want to keep drains clear. This should be done once a month, and a cup each of baking soda and vinegar should be used. Cover the drain with a plug or rag as you wait for the chemical reaction between the vinegar and baking soda to happen in your pipes. Pause a few minutes, and then follow the mixture with boiling water. This should help clear your pipes of accumulated hair and soap scum.

TIP! Always use cold water when your garbage disposal is running. The cold water helps keep the blades sharp and can make disposal much smoother.

Knowing your tools and how to use them can help greatly in your plumbing experience. So be sure to read through all your manuals as well as research as much as you can on the internet where you can gain information to help you with your projects. Make sure you plan before you try any kind of repair, as it can be costly to fix a mistake.

You can resolve most toilet clogs yourself. Try a plunger first. If plunging the toilet doesn’t seem to clear up a clog, check the toilet’s water level. If it’s too low, try filling a bucket with warm water. Open the toilet’s tank, and pour the water in. Repeat this as many times as necessary until your clog is gone, and you can flush normally once again.

Do not pour grease or other oils in your sink or down your drain. These substances will create clogs after cooling in your drain. This is especially damaging to garbage disposals because the fat can make the blades turn more slowly and less efficiently. Be sure to get rid of oil products away from your sink.

To minimize potential problems with your toilet, avoid using it as a trash receptacle. Do not flush sanitary pads, paper towels, cotton balls, tissues, diapers or other materials, as these items do not dissolve and could cause clogs. Even keep toilet paper use to the minimum necessary.

TIP! Superior quality is important when it comes to shower fixtures. It’s common to think it’s fine to buy the one that is the cheapest.

Pour equal parts baking soda followed by vinegar down your bathtub drain once a month. Afterward, place a washcloth or towel over the top of the drain, to keep the chemical reactions contained. After about 10 minutes you can flush the pipes out with boiling water. Doing this will help rid your pipes of disgusting soap scum and blockages.

Plumbing System

Are you now more aware about how plumbing works? Do you have more of an understanding on what kind of plumbing system is in your home? Have your plumbing skills increased? Can you use components to your plumbing system now? Are you knowledgeable on how to use the equipment properly? Hopefully, after reading this article, your answer to all these questions is a resounding yes.

If you need to remove a clean out plug, and you are not having much luck, there are two methods used to help you do this. The first one is to use a hammer and chisel to attempt loosening the fitting. Unfortunately, if you still cannot remove the plug, the only viable option left on the table is to bust right through the plug completely with the hammer and chisel.

Share Button